STEP 2: Application

Once you have properly prepared the concrete surface and adjacent walls and doors, it is time to start applying the Deco-Etch.

For small areas use a sponge or paintbrush.

Do Not Pour Stain On Floor!!!

For larger areas we recommend the use of a pump up sprayer or a Lambswool Applicator. Deco-Etch Stain is corrosive therefore an acid resistant sprayer would be recommended if sprayer is to be used multiple times. (Note: If the room is finished except for the floors, the lambswool applicator will minimize the chance of staining walls and baseboards.)

Apply a single uniform coat of Deco-Etch Stain that completely covers the concrete. Do not over apply. Coverage rate should be approximately 200 sq. ft. per gallon. Coverage rate will vary with porosity of floor. Let the first coat dry completely. Drying time will also vary with the porosity of floor. Usual dry time is about 8 hours. Apply second coat in the same manner.

In lower picture, the use of a paint shield kept the Deco-Etch off of the walls.